Matronics Email Lists

Great idea on how to construct the wire harnes.....Thanks for the
information!
Dan

---

Peter,
Oops....you are correct on the alternator wire. The drawing should have had the output wire of the alternator going to the other side of the starter contactor. Thanks for the catch!
In as ...

What are thoughts on creating the electrical wiring harness? I've attached the embrionic schematic (lot's of final design, editing and cleanup to do) just to convey the simplicity of my Zenith CH750 ...

I can't imagine the time, money and effort that goes into this kind of an
effort. Speaking from the standpoint of a casual user, I appreciate
the list and the ability to take advantge of the advice ...

All:
Thanks for the replies. I do have a question into Zenith, and as Bob mentions they do indicate a test by where you measure fuel flow at elevated (simulated climb) angles. They also have pictu ...

I haven't purchased an engine yet but plan on using an O-200 (perhaps the O-235) on the CH750, which is a high wing design. Fuel tank is in the wing, so it's essentially gravity feed. Reading " ...

I'm putting together an electrical load analysis spreadsheet and can find most continuous and intermittent electrical loads for the devices I've selected. I'm building a Zenith CH750 that will be si ...