Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Dilemma(s)

Matronics Email Lists Forum Index -> Europa-List

View previous topic :: View next topic

Author Message

VE3LVO(at)rac.ca
Guest

Posted: Tue Jun 27, 2006 1:57 pm Post subject: Dilemma(s)

Cheers,

            .....installing the coolant rad and the oil cooler :

        I took the opportunity to lower the oil cooler the suggested 2 

inches. If you did this, what parts did you order?   I note a suggestion 

that the bent tube on one side should be replaced by a 'straight' tube but 

the ones supplied by Rotax are too short and the nipple ends up inside the 

duct - where it would be difficult to clamp it with the cooler in place. 

What have I done wrong?

        The 914 installation manual seems to leave a lot of the details out.



            On another bent, the manual suggests the cooling duct which 

slides down twixt the footwells may be attached to the inside walls by means 

of a -3 bolt and an MS 21042-3 anchor nut "installed in reverse".  I can't 

seem to imagine the arrangement..... Can someone enlighten me please?

Happy landings

Ferg Kyle

Europa A064 914 Classic

- The Matronics Europa-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List

tonyk(at)kaon.co.nz
Guest

Posted: Tue Jun 27, 2006 3:38 pm Post subject: Dilemma(s)

Ferg



Get another straight one from Europa. These are long enough to allow you

to drop the cooler.



For the MS21042-3, drill out an initial 3/16" hole then countersink it,

from within the tunnel, large enough to accept the raised part of the

nut. When you fit the nut you'll be fitting it so that the plate is

mounted on the tunnel wall but with the raised part embedded into the

countersunk area.



Tony



--

- The Matronics Europa-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Europa-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum