trigo(at)mail.telepac.pt
Guest
|
 Posted: Wed Nov 06, 2019 4:25 pm Post subject: Using a BNC “T” |
 |
|
Guys
I’m sure this has been asked (and answered) before, but I am too old for my memory to remember of it, and too lazy to look for it in the archives...
I have just installed a 2nd Comm antenna in my aircraft, a plain vanilla RAMI AV-10, which is intended to be used either by a future Comm 2 radio or by a hand-held radio which I will carry in my flight bag.
For that purpose I installed 2 antenna cables, one which goes from the antenna to the place where I planned to put the future Comm 2 radio, and the other cable goes from the antenna to somewhere near the pilot seat, where a loose end with a female BNC connector will be connected to the hand-held radio in case I need to use it.
So, the question is: is it ok to install a “T” like these
[img]cid:C2CE3A3B-E720-40CE-B7FF-09E44746BC95[/img]
below the antenna, and connect to it the 2 cables mentioned above?
Thanks
Carlos
Enviado do meu iPhone
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
| Description: |
|
| Filesize: |
47.08 KB |
| Viewed: |
1025 Time(s) |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
