Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Flowscan bushing

Matronics Email Lists Forum Index -> RV10-List

View previous topic :: View next topic

Author Message

cjhukill(at)cox.net
Guest

Posted: Tue Nov 28, 2006 7:21 am Post subject: Flowscan bushing

I reamed the Flowscan to accept a standard aluminum  bushing to allow for a AN3 bolt, and removed enough material to penetrate the  sender's wall, and cause it to leak. ( these are VERY thin walls) After  spending another $250 to replace the sender, I then turned down a  couple  more bushings on the lathe, so they would fit the existing holes in the  Flowscan, without removing any material from the Flowscan.

 Anyone need a leaky Flowscan, Cheap?

  

 Chris Hukill

 buildus interuptus during major home  remodel

 (I though airplane parts were  expensive!)

    [quote][b]

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV10-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum