Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

cylinder baffles

Matronics Email Lists Forum Index -> RV-List

View previous topic :: View next topic

Author Message

wnorth(at)sdccd.edu
Guest

Posted: Fri Dec 29, 2006 11:20 pm Post subject: cylinder baffles

I use an 1/8 or 3/16 inch cotter pin through each hole facing away from the

safety wire run through a hole the lower baffle flanges and a backup #8

steel washer. Bend the cotter pin legs out so they lay along the flange then

run the safety wire through the eyelet now made from the round end of the

cotter pin.



I use 6 inches of -2 aeroquip hose as a chafe guard around the return tubes

and two full laps of .041 safety wire fed through the hose and then

throughly twisted that runs most of the way, then one small double loop to

attach the other end and pull it tight.



I also glue on some 1/16 inch rubber sheet to the parts that lay against the

steel fins to prevent chafing cuts in the baffle.



W

- The Matronics RV-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum