Matronics Email Lists :: View topic - Elevator Trim Motor Wiring Routing

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Elevator Trim Motor Wiring Routing

Matronics Email Lists Forum Index -> RV8-List

View previous topic :: View next topic

Author Message

stazel(at)cpros.com
Guest

Posted: Wed Sep 02, 2009 8:56 am Post subject: Elevator Trim Motor Wiring Routing

Should have addressed this sooner.  The  leading edge is rolled and riveted, and I now realize that the existing hole  through the spar won't work.  I think this has been a past subject on the  list, but didn't pay attention at the time.  Difficult, but probably not  impossible to drill a new routing hole inboard.  Would have to open up the  leading edge for access.  Plan B might be to drill a hole through the butt  rib concentric with the forward lightening hole in the horn  bracket.  Recommendations greatly appreciated.

  

 Stan Loer

 stazel(at)cpros.com (stazel(at)cpros.com)    

    [quote][b]

- The Matronics RV8-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV8-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum