Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Rudder TE Gap

Matronics Email Lists Forum Index -> RV-List

View previous topic :: View next topic

Author Message

PFolbrecht(at)starkinvest
Guest

Posted: Thu Apr 27, 2006 6:19 am Post subject: Rudder TE Gap

After riveting, one of the skins is not flush against the wedge.  The

rivets are, but not the edge.  Riveting curled it up a bit, it seems,

just on that side.  Would using a hand seamer here to get these surfaces

flush be an Ok idea?  Perhaps I should have pre-curled the edge, though

I don't think that would have helped.  (Turns out I used a bit too much

'hit' when back-riveting, and have some minor indentations as well.

Wish I could do it over.)



=20



Do not archive =20

- The Matronics RV-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum