Carlos Sa
Joined: 13 Jan 2006
Posts: 96
|
 Posted: Wed May 10, 2006 7:03 pm Post subject: RE : Hole/Fly Cutter |
 |
|
Randy, I've been using a "hardware store grade" one with decent results.
All (CH601-HD) rib and spar lightening holes done.
Good luck
Carlos
do not archive (after all, it's just 2 cents)
--- Randy Bryant <randy(at)shadycreekoutlaws.com> a crit :
| Quote: |
I made my first wing rib tonight! RR#1... It turned out great! =
Straight as an arrow, nice clean crimps...etc... THEN I went to cut the =
lightening holes and my hole/fly cutter is a piece of crap I bought off =
eBay, and it cut the hole to 120mm... I've had trouble with this hole =
cutter on the holes I've cut so far and have grown to hate it. That's =
OK for now, I'll just hang the scrap rib on the wall as a reminder... =
BUT, I'd like not make the same mistake again...
Can anyone point me to a good hole/fly cutter to do this job?
Thanks in advance,
Randy
XL Wings - Plans Only
http://www.N344RB.com
|
__________________________________________________________
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
CH601-HD, plans
Montreal, Canada |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
