Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Low Fuel Flow Indication

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List
View previous topic :: View next topic  
Author Message
JohnF



Joined: 13 May 2010
Posts: 124

PostPosted: Thu Dec 08, 2011 10:06 am    Post subject: Low Fuel Flow Indication Reply with quote

RV-12 912 ULS 53 hrs

Flew this morning in 24-degrees F after a previous night of -12F. Plane in hangar, this morning, 1.5-hrs with heater on, oil was up to over 75-deg F and engine started instantly, mag check typical drop, all normal. Take off 5100 or so RPM and 960 FPM climb. Leveled off at 9,000 MSL and 5,000 RPM then noted fuel flow of only 3.3-GPH. Typical is 4.0 or 4.1 but everything was working normally and increasing RPM increased fuel flow reading. Indication is on a Dynon D-180.

On landing I stopped on taxi way and left engine idle at 2100 or so and fuel flow showed 0.0 GPH

My "guess" is that the cold soak the previous night somehow effected the impeller in the fuel flow module and more or less slowed it down ... gas was also cold.

Your take?

John
[quote][b]


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
View user's profile Send private message Send e-mail  
Thom Riddle



Joined: 10 Jan 2006
Posts: 1597
Location: Buffalo, NY, USA (9G0)

PostPosted: Fri Dec 09, 2011 5:01 am    Post subject: Re: Low Fuel Flow Indication Reply with quote

John,

What altitude do you normally cruise at? If this flight was at a higher density altitude(DA) than previous flights you should expect a decrease in fuel consumption. At higher DA, if you fly at same a rpm as at lower DA, your engine is producing less power. It takes more RPM on fixed pitch prop to produce the same power as at lower DA.

If this flight is at about the same DA as previous flights, perhaps the engine is loosening up a bit. New engines are frequently tight which results in more friction drag and more fuel consumption for a given rpm at same conditions.


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List

_________________
Thom Riddle
Buffalo, NY (9G0)



Don't worry about old age... it doesn't last very long.
- Anonymous
Back to top
View user's profile Send private message Send e-mail  
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group