dan(at)azshowersolutions.
Guest
|
 Posted: Sat Apr 10, 2010 10:32 am Post subject: Starter |
 |
|
I have been getting my 912s ready to hang on the firewall of my Kitfox. I am in need of cutting the bolt hole (ears) off of the starter as they will not be used...needing to gain more clearance. has anyone ever taken the cap off of the starter to cut the ears off? This is where the hot lead screw is at and I'm thinking the brushes must be close by. Am I in for a rodeo if I take this cap off?
Thanks,
Dan
From: Robert Borger <rlborger(at)mac.com>
To: "rotaxengines-list(at)matronics.com" <rotaxengines-list(at)matronics.com>
Sent: Sat, April 10, 2010 7:50:38 AM
Subject: Re: Re: Rotax 914 Fuel PumpsRe: Rotax 914 Fuel Pumps
Hi Dick,
Thanks, I'll take you up on the offer. I'll contact you off-line when I grt home.
Bob Borger
Sent from my iPhone
On Apr 10, 2010, at 9:02, Catz631(at)aol.com (Catz631(at)aol.com) wrote:
[quote] I too just bought a new gasket from LEAF for my 912 fuel pump. If you need a gasket and the 912 gasket will fit you could have my old one.It is in perfect condition I shouldn't have bought the new one. They run about $35 !
Dick Maddux
Milton,Fl
[b]
| | - The Matronics RotaxEngines-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RotaxEngines-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
