joeing701(at)simnet.is
Guest
|
 Posted: Mon Nov 22, 2010 7:56 am Post subject: RotaxEngines-List Digest: Rough running cured with carb hea |
 |
|
Hello Doug.
Thank you for this info.
We will make sure that the enrichener is working accordingly.
Best regards,
Johann G.
Iceland.
----- Upprunalegt skeyti -----
Frá: "MacDonald Doug" <dougsnash(at)yahoo.com>
Til: rotaxengines-list(at)matronics.com
Sent: Mánudagur, 22. nóvember, 2010 11:25:24 GMT +00:00 Monrovia
Efni: Re: RotaxEngines-List Digest: Rough running cured with carb heater
Johann, check to make sure that the enrichener arms are seating correctly in the off position. I had a similar issue with my engine. Ine of the gurus from Lockwood pointed out to me that since the enrichener circuit is not a choke, it actually causes a LEAN condition at higher RPMs.
Doug MacDonald
CH-701 C-GBQX
NW Ontario, Canada
| Quote: | Hello list members.
I have a friend who has been having problems with the Rotax
912 UL in
a Kitfox 3. When flying today in a temp. around 40F,
the engine ran
rough until he pulled the carb heat on. Ran very smooth and
never as
good.
What do you think could cause this problem? We measured the
carb
levels and they are very similar. 1/8 of an inch. One carb
was
definitely running bad because the EGT dropped on one
exhaust.
No carb ice and the carbs have been rebuild. Any ideas?
Johann G.
Iceland.
Zenith 701
Rotax 912UL.
|
| | - The Matronics RotaxEngines-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RotaxEngines-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
