N38CW
Joined: 16 Apr 2008
Posts: 57
Location: Winston-Salem, NC
|
 Posted: Wed Jan 30, 2013 1:26 pm Post subject: No Title |
 |
|
Bob,
I'm trying to figure out my LED Nav lights and I have a couple of questions: I bought a set of wingtip LED Nav lights from a builder off of VAF who was producing them prior to you offering your LuxDrive filters. They came with 700mA LuxDrive Power Pucks. After you started offering your filters, I bought a couple of those. They came with 1000mA Power Pucks. Can I use the 1000mA models or should I reorder 700mA units?
When I received the filters, it came with a hand written sketch for a wiring diagram. I have since downloaded a newer schematic from your website. Comparing the two, I see there is a difference in them concerning pins 2 & 3. On the original hand written one, both pins are labeled “N/C”. I assume this means “Not Connected.” (?) The newer schematic shows pin 2 as 5v ref and pin 3 as “Control Dimming.” As I am not considering dimming my Nav lights, I don’t need to connect these, correct?
Also, on both drawings, pins 4 & 8 and pins 5 & 9 are common with each other. Is this for one filter to drive two different Nav lights?
Thanks,
Bill Settle
RV-8
[quote][b]
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
_________________
Bill Settle
RV-8 Fuselage |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
