Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

HANDHELD COMM. PROBLEMS/////

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kitfox-List
View previous topic :: View next topic  
Author Message
5324(at)PRTC.NET
Guest





PostPosted: Wed Oct 25, 2006 6:32 am    Post subject: HANDHELD COMM. PROBLEMS///// Reply with quote

HELO: LIST

I HAVE A ICOM A-5 ON MY FOX.. WITH FLIGHT TECH INTERCOM AND EXTERIOR
ANTENNA...

IN GROUND THERE NO PROBLEMS IN RE&TRA///

BUT IN FLIGHT/// EVERYBODY THAT COPY ME SAID THAT TOO MUCH INTERFERENSE
OCCURS////

DO ANY RECOMENDATIONS!!!!!!!

PEDRO
CLASSIC N212PR
PUERTO RICO
============================================================
Quote:





- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List
Back to top
Float Flyr



Joined: 19 Jul 2006
Posts: 2704
Location: Campbellton, Newfoundland

PostPosted: Wed Oct 25, 2006 9:13 am    Post subject: HANDHELD COMM. PROBLEMS///// Reply with quote

I have the A-24 and I did have the same problem..... It came form a problem
I had with my engine that actually shorted out the resistors in the spark
plugs. The CDI in the 582 does give off a pretty healthy spark and if the
resistor clips are worn or if the resistor plugs are not showing the correct
resistance ( I think 5 M Ohms) then you can count on TX noise on your
signal. Funny thing is the RX won't be nearly so bad.

These new super small X-cievers use the same boards to do several different
tasks in side the radio. Those boards are what is picking up the noise of
your engine and pumping it up the pipe.( antenna )

Hope this helps... The fix isn't hard, Good resistor caps on good resistor
plugs.
Noel

[quote] --


- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List

_________________
Noel Loveys
Kitfox III-A
Aerocet 1100 Floats
Back to top
View user's profile Send private message Send e-mail
Guy Buchanan



Joined: 16 Jul 2006
Posts: 1204
Location: Ramona, CA

PostPosted: Wed Oct 25, 2006 10:35 am    Post subject: HANDHELD COMM. PROBLEMS///// Reply with quote

At 07:27 AM 10/26/2006, you wrote:
Quote:
BUT IN FLIGHT/// EVERYBODY THAT COPY ME SAID THAT TOO MUCH INTERFERENSE
OCCURS////

DO ANY RECOMENDATIONS!!!!!!!

I did some research on this a while ago and found some information related
by a open cockpit builder. He said one way to increase the signal to noise
when transmitting was to turn the mic gain down and talk louder. I did that
with my A200 and it seemed to work. I doubt you can do that with a
hand-held. The only other recommendation would be to use a high quality
headset with it with a noise cancelling mic.
Guy Buchanan
K-IV 1200 / 582-C / Warp / 100% done, thanks mostly to Bob Ducar.


- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List

_________________
Guy Buchanan
Deceased K-IV 1200
A glider pilot too.
Back to top
View user's profile Send private message Send e-mail
kitfox(at)ida.net
Guest





PostPosted: Thu Oct 26, 2006 6:14 pm    Post subject: HANDHELD COMM. PROBLEMS///// Reply with quote

I am sorry, i missed the origional post. So am jumping in the middle. You
have to determine if it is elec. generated noise from the motor or noise
from the external. Try using the radio as a handheld only, no external any
thing and go from there. I use an A5 in my Fox and it works great. It is
powered from the 12 v system power and with an external antana. Is the noise
also from the mics or the radio.
Albert Smith


- The Matronics Kitfox-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kitfox-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group